====== Alcatel OXO ======

The DuVoice 7.00 can link to an Alcatel OmniPCX Enterprese (OXO)  PBX using a TCP connection where the PBX is the server.  This link uses the protocol and features listed in the table below:

|< 80% 15% 20% 20% >|
^Link Type^Protocol Used^Log File Prefix^Features Supported^
|//TCP Client//|//OHL (version R2.3.8, edition 2.1)//|ALCATELOXO|Check In, Check Out, Name Change, Language, Maid Status, Controlled Restriction, DND|

This page is used to configure the 7.00's link to the Alcatel OXO.

{{:images:vs7:manual:pbxlink-alcateloxo.png?nolink|}}

The settings are grouped into two categories:  //Network// and //Overrides//.  Configure the settings as needed and then click **OK** to save your changes and close the dialog.  Or click **Cancel** to discard any changes and close the dialog.

===== Network Settings =====

|< 85% 20% 15% >|
^Setting^Default^Description^
|//IP or DNS Name//|(blank)|Enter the IP address of the PBX.|
|//TCP Port number//|5001|Enter the port number to connect to on the PBX.|

===== Overrides =====

|< 85% 20% 15% >|
^Setting^Default^Description^
|//Polling Interval//|300|Enter the number of seconds to wait between polling (keep-alive) messages.  Ideally, this should not be less than 60 seconds unless the PBX requires it.|
|//Transmit Delay//|500|Enter the time, in milliseconds, that the voice server should wait after sending a message (and receiving the ACK response) before it can send another message.\\ \\ The default is 500 ms (half a second).  If the PBX is getting overwhelmed, you can increase this value to artificially slow the pace of message traffic.|