====== HTTP Post ======

The DuVoice 7.00 can connect to a PBX using HTTP Post, if the PBX supports this protocol.  This link uses the protocol and features listed in the table below:

|< 80% 15% 20% 20% >|
^Link Type^Protocol Used^Log File Prefix^Features Supported^
|//TCP Client//|//HTTP, HTTPS//|HTTPPOST|Name Change, Set user rights group (phone COS), DND|

This page is used to configure the 7.00's link to a PBX using HTTP Post.

{{:images:vs7:manual:pbxlink-http.png?nolink|}}

The settings are grouped into two categories:  //Network// and //Scheduling//.  Configure the settings as needed and then click **OK** to save your changes and close the dialog.  Or click **Cancel** to discard any changes and close the dialog.

===== Network Settings =====

|< 85% 20% 15% >|
^Setting^Default^Description^
|//URL//|(blank)|Enter the URL to post information to.\\ \\ //**If you are using SSL connections, make sure the URL starts with HTTPS.**\\ \\ You may specify a port number other than 80 or 443 by adding it to the URL  For example, the URL ''<nowiki>https://192.168.1.25:4010/pbx</nowiki>'' would establish an SSL connection to 192.168.1.25 over port 4010.//|
|//Username//|(blank)|Enter the user name required to login to the PBX, if needed.|
|//Password//|(blank)|Enter the password required to login to the PBX, if needed.\\ \\ **If //Username// is specified, then a password is also required.**|

===== Scheduling =====

|< 85% 20% 15% >|
^Setting^Default^Description^
|//Retries//|3|Number of times to resend a post that is rejected or otherwise fails. \\ \\ //Default is 3 retries (for a total of four attempts).//|
|//Interval (seconds)//|60|Enter the number of seconds to wait between retries.|
|//Timeout//|10|Enter the length of time, in seconds, to wait for a response from the server.\\ \\ //A timeout counts as a retry.//|