====== IPitomy ======

The DuVoice 7.00 can connect to an IPitomy PBX using HTTP Post, if the PBX supports this protocol.  This link uses the protocol and features listed in the table below:

|< 80% 15% 20% 20% >|
^Link Type^Protocol Used^Log File Prefix^Features Supported^
|//TCP Client//|//HTTP, HTTPS//|IPITOMY|Name Change, Set user rights group (phone COS), DND, MWI|

This page is used to configure the 7.00's link to an IPitomy PBX using HTTP Post.

{{:images:vs7:manual:pbxlink-ipitomy.png?nolink|}}

The settings are grouped into two categories:  //Network// and //Scheduling//.  Configure the settings as needed and then click **OK** to save your changes and close the dialog.  Or click **Cancel** to discard any changes and close the dialog.

===== Network Settings =====

|< 85% 20% 15% >|
^Setting^Default^Description^
|//URL//|(blank)|As shown in the dialog above, this connection must use HTTPS.  Replace the IP address with the IP address of your PBX.\\ \\ //You **must** include the ''/ippbx/restsvc'' part following the IP address, as shown in the dialog above.//|
|//Username//|(blank)|Enter the user name required to login to the PBX, if needed.|
|//Password//|(blank)|Enter the password required to login to the PBX, if needed.\\ \\ **If //Username// is specified, then a password is also required.**|
|//Authorization ID//|(blank)|Enter the authorization ID to use when communicating with the PBX.\\ \\ //This is configured under **Applications | External Apps** from within the IPitomy configuration.//|
|//Authorization Key//|(blank)|Enter the authorization key to use when communicating with the PBX.\\ \\ //This is configured under **Applications | External Apps** from within the IPitomy configuration, and is listed under **Authorization Phrase**.//|

===== Scheduling =====

|< 85% 20% 15% >|
^Setting^Default^Description^
|//Retries//|3|Number of times to resend a post that is rejected or otherwise fails. \\ \\ //Default is 3 retries (for a total of four attempts).//|
|//Interval (seconds)//|60|Enter the number of seconds to wait between retries.|
|//Timeout//|10|Enter the length of time, in seconds, to wait for a response from the server.\\ \\ //A timeout counts as a retry.//|