====== Avaya IP Office ======

The DuVoice 7.00 can link to an Avaya IP Office PBX using a TCP connection where the PBX is the server.  This link uses the protocol and features listed in the table below:

|< 80% 15% 20% 20% >|
^Link Type^Protocol Used^Log File Prefix^Features Supported^
|//TCP Client//|//IP Office Config. Service, TAPI (for DND)//|IPOFFICE|Name Change, Set user rights group (phone COS), DND|

This page is used to configure the 7.00's link to the IP Office.

{{:images:vs7:manual:pbxlink-ipoffice.png?nolink|}}

The settings are grouped into two categories:  //Network// and //Scheduling//.  There is also a button for loading the IP Office driver if needed.  Configure the settings as needed and then click **OK** to save your changes and close the dialog.  Or click **Cancel** to discard any changes and close the dialog.

===== Network Settings =====

|< 85% 20% 15% >|
^Setting^Default^Description^
|//IP or DNS Name//|(blank)|Enter the IP address or domain name of the PBX.|
|//TCP Port number//|5001|Enter the port number to connect to on the PBX.|
|//Username//|(blank)|Enter the user name required to login to the IP Office.|
|//Password//|(blank)|Enter the password required to login to the IP Office.|
|//DND Support//|None|Select the type of support to use for passing DND status to/from the PBX.\\ \\ ''None'': DND support is disabled.\\ ''DND CheckBox Extension is busy with no forwarding'': When DND is on, extension will signal busy.\\ ''Enable Forward Unconditional'': When DND is on, calls will be forwarded as configured.|

===== Scheduling =====

|< 85% 20% 15% >|
^Setting^Default^Description^
|//Retries//|3|Number of times to retry sending a change request to the PBX if the first attempt fails for some reason. \\ \\ //Default is 3 retries (for a total of four attempts).//|
|//Interval (seconds)//|60|Enter the number of seconds to wait between attempts to send a change request if the PBX does not respond.|
|//Enable TAPI Support//|Disabled|Check this box to enable TAPI support.|

===== Driver Installed =====

|< 80% 20% >|
^Setting/Button^Description^
|//Version//|Displays the version of the driver that is installed, or 'None' if it is not installed.|
|//Install//|Click this button and follow the instructions displayed if you need to install the driver.|