====== Metaswitch ======

The DuVoice 7.00 can connect to a Metaswitch PBX (version 8.2 or above) using TCP/IP.  This link uses the protocol and features listed in the table below:

|< 80% 15% 20% 20% >|
^Link Type^Protocol Used^Log File Prefix^Features Supported^
|//TCP Client//|//Proprietary Metaswitch protocol//|METASWITCH|Name Change, Set user rights group (phone COS)|

This page is used to configure the 7.00's link to a Metaswitch PBX.

{{:images:vs7:manual:pbxlink-metaswitch.png?nolink|}}

The settings are grouped into two categories:  //Network// and //Scheduling//.  Configure the settings as needed and then click **OK** to save your changes and close the dialog.  Or click **Cancel** to discard any changes and close the dialog.

===== Network Settings =====

|< 85% 20% 15% >|
^Setting^Default^Description^
|//Username//|(blank)|Enter the user name required to login to the PBX.|
|//Password//|(blank)|Enter the password required to login to the PBX.|
|//IP or DNS Name//|(blank)|Enter the IP address or domain name of the PBX.|
|//TCP Port number//|''8080''|Do not change from the default value 8080 unless the port for this interface has been changed on the PBX.|
|//HTTS//|(unchecked)|Check this box to use the HTTPS protocol.|
|//Switch name//|(blank)|Enter the name given to your PBX. //Case sensitive.//|
|//Business group//|(blank)|Enter the business group associated with the guest rooms. //Case sensitive.//|

===== Scheduling =====

|< 85% 20% 15% >|
^Setting^Default^Description^
|//Retries//|''3''|Enter the number of times to retry if an attempt to change subscriber settings fails./|
|//Interval (seconds)//|''90''|Enter the number of seconds to wait between retries.|