====== Panasonic KX-NS (FOSI) ====== The DuVoice 7.00 can link to an Panasonic KX-NS1000 PBX using a TCP connection where the PBX is the server. This link uses the protocol and features listed in the table below: |< 80% 15% 20% 20% >| ^Link Type^Protocol Used^Log File Prefix^Features Supported^ |//TCP Client//|//Panasonic FOSI//|PANASONICFOSI|Check In, Check Out, Room Move, Name Change, Language, Maid Status, Controlled Restriction, DND| This page is used to configure the 7.00's link to the Panasonic KX-NS1000. {{:images:vs7:manual:pbxlink-panasonickxns.png?nolink|}} The settings are grouped into two categories: //Network// and //Overrides//. Configure the settings as needed and then click **OK** to save your changes and close the dialog. Or click **Cancel** to discard any changes and close the dialog. ===== Network Settings ===== |< 85% 20% 15% >| ^Setting^Default^Description^ |//IP or DNS Name//|(blank)|Enter the IP address of the PBX.| |//TCP Port number//|5001|Enter the port number to connect to on the PBX.| ===== Overrides ===== |< 85% 20% 15% >| ^Setting^Default^Description^ |//Polling Interval//|300|Enter the number of seconds to wait between sending keep-alive messages. Ideally, this should not be less than 60 seconds unless the PBX requires it. \\ \\ Setting this value to 0 will disable polling altogether (however, the PBX may send keep-alive messages itself).| |//Transmit Delay//|500|Enter the time, in milliseconds, that the voice server should wait after sending a message (and receiving the ACK response) before it can send another message.\\ \\ The default is 500 ms (half a second). If the PBX is getting overwhelmed, you can increase this value to artificially slow the pace of message traffic. \\ \\ Setting this value to 0 will disable the transmit delay so that the 7.00 will send messages as fast as possible.| |//Wait for response timeout//|15|Enter the number of seconds to wait for a response after sending a message and before assuming the PBX will not respond. Vaild range is 5 to 30 seconds.|